It means the processor cant see the speakers. You do have the speakers connected to the amp through the SRC1, yes? Otherwise, cable fault or busted speaker. If you are using only one half of an SRC1 (ie mono), you need to put a resister across the unused other half, or the SRC1 determines theres no speaker, and goes into error shutdown mode. Recent Celestion S20 Subwoofer questions, problems & answers. Looking for a celestion sr1 manual. Celestion Audio.| Posted on Feb 08, 2013. Celestion SRC4 Controller (UK Voltage) - CLEARANCE - Celestion SRC4 Controller (UK Voltage) 'Dedicated 2-input 3-output controller for the SR1' - Now on. Medal of honor allied assault breakthrough cd key code. Find great deals on eBay for Celestion Speakers in Home Speakers and Subwoofers. Shop with confidence. Blue Room technical forum: Bose 802 vs Celestion SR1 - Blue Room technical forum. Thank you so much for your reply, Yes I have the speakers hooked up in parallel mode to the output of the amp and the input from the amp into the full range/hi amp connector on the src1. I'm pretty sure the speakers are ok. I have 5 sr1's and I've tried each of them although I have not heard them work yet lol. The individual I got them from used them before just fine. I'm using the setup on figure 'a' on the src1. I'm obviously doing somthing wrong. Can you give me an example of using half of the src1 or how would I aquire some sort of resister for this purpose? I'm pretty sure this may be my problem is how I'm connecting the amp into the src1. I'm a newb with this stuff but I'm learning. Thank heck for the web! Figure A is correct, and shows using one half of the SRC1. For stereo, you need to do the same thing again to the other set of connectors,for the other half of the SRC1, so dupicate diagram A onto the second set of connectors, so you use both halves of the SRC1. Celestion Sr1Celestion Sr1 Mk2If you are using just one amp channel and one or more speakers, you need to convince the unused half of the SRC1 that it is in use. To do this, leave all the unused half connectors unconnected, except you fit a 10 ohm resistor (maplin M10R will don fine) across the unused speaker connector bannana plugs. That convinces the SRC1 there is a speaker connected Since you have five speakers - note that only one goes through the SRC1 per channel; any others are just paralleled onto the amplifiers output.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |